Cables

When the Interface 1140 is connected to the alternator AC it can measure ripple/frequency.The assistant 'Use 1140 interface to set shore limit assistant' can be used in Multi(C) or a Quattro. It is connected just as a MK2 with use of an UTP cable...

The VE.Direct TX digital output cable can be used in combination with the BlueSolar and SmartSolar MPPT chargers. It supports the following applications:- Solar lighting applications- Virtual load output

Use this cable to remotely control BlueSolar and SmartSolar MPPT charge controller models. Note that it's not necessary to use this cable on the larger SmartSolar models, as they feature an onboard Remote On/Off terminal. The charger will be enabled when...

Use this cable to connect the following products to the VE.Bus BMS: - Skylla-TG all models - Battery Protect models BP40i, BP60i and BP200i (all discontinued). The cable translates the remote on/off driver logic from the VE.Bus BMS (normally high,...

Use this cable to connect the (discontinued) Phoenix Inverter 12/180, 24/180, 12/350 or 24/350 to a VE.Bus BMS or a BlueSolar MPPT Charger that features a load output: VE.Bus BMS: the Inverter will be switched off when the batteries are emptyBlueSolar...

Use this cable to connect a CAN-bus enabled battery, not from Victron, to a Victron system. There are two types, A and B. See the manual for details on which cable to use for which brand of batteries.

Use this cable to connect a CAN-bus enabled battery, not from Victron, to a Victron system. There are two types, A and B. See the manual for details on which cable to use for which brand of batteries.

Use this cable to connect a CAN-bus enabled battery, not from Victron, to a Victron system. There are two types, A and B.